Jiangyin Tsinghua Foamplastic Co.,Ltd

添加会员

求助

回首页

公司简介

产品橱窗

影音视听

寄出询问函

联络我们

	Recommended Results

产品型录

共5 笔产品

选定全部

取消全部

1. EPS CNC cutting machine

The cnc cutting machien is used for cutting EPS shape such as decoration volumes and flat siding sheet. After drawing input, the impulse signal will be sent to controller from PC and then drive the X-axis(EPS block conveyer belt) and Y-axis(cutting ...

2. EPS cutting machine

Three-direction cutting, horizontal, vertical and cross cutting
Max 50 cutting wires can be manually set in horizontal direction,
and max 10 cutting wires in vertical direction
One wire is used to cut to length
Minimum thickness to be cut ...

3. EPS block molding machine

1. Touch screen system
2. Action controlled by PLC, hydraulic, compressed air.
3. Single-door opening with energy saving
4. Steam inlet controlled by ball valve
5. The automatic material feed guns controlled by vacuum with high efficiency ...

4. EPS continous pre-expander

1. Repetitious expansion to get low density material
2. Square layout design with isolation layer
3. Stainless steel chamber
4. Easy to operate

5. EPS batch pre-expander

1. 5 Safety devices.
2. Pressure Reduce Valve from Japan.
3. HMI and PLC are from Taiwan,all the parameter can be set and revised in the screen.
4. weight control of raw material with dust separator
5. prevent temperature reduce
6. ...